Leaking or Cold Water Heater: First Ten Minutes

If water is pooling around the tank, close the cold water shutoff on the pipe above the heater. Turn the gas valve to off on a gas unit, or switch the breaker off on an electric unit, so nothing heats an empty tank.

Then call the line. Tell dispatch whether the water is coming from the top fittings, the relief valve pipe or the tank bottom, because a bottom leak almost always means the tank has failed and the next step is replacement.

What Is Wrong With Your Heater

Symptoms point to specific parts. This table shows the usual match for a standard tank heater.

Symptom guide for tank heaters
What you noticeLikely causeRepair or replace
Water at the base of the tankCorroded tank or a failed drain valveReplace if the tank leaks. Repair if it is the valve.
Water from the relief valve pipeExcess pressure or a worn valveRepair. Check the expansion tank too.
No hot water on a gas heaterPilot, thermocouple or gas valveRepair
No hot water on an electric heaterHeating element or thermostatRepair
Rumbling or poppingSediment baked onto the tank floorFlush if early. Replace if the tank is old.
Rusty hot water onlyAnode rod gone or tank interior rustingAnode swap if early. Otherwise replace.

A plumber confirms the cause on site, so treat the table as a guide only.

No hot water or a leaking tank?

Call the 24/7 line and describe what you see. Dispatch will talk you through shutting the water and gas off.

Call (773) 207-0518

Gas and Electric Tank Repairs We Handle

Most Burbank homes run a gas or electric tank heater in the basement, utility room or garage. The repairs below cover the common failures.

Gas heaters

Gas units depend on a clean burn and a working flue. A technician checks the pilot assembly, thermocouple, gas control valve and venting, and tests for draft before leaving the unit on.

Electric heaters

Electric units usually fail at an upper or lower element or at a thermostat. We test the elements for continuity and replace the failed part.

Relief valves and drain valves

The temperature and pressure relief valve is a safety part. If it drips or discharges, we check the water pressure and the expansion tank before we replace it.

Worth knowing

Burbank Rule on Gas Water Heater Replacement

The City of Burbank Building Department offers a free inspection on gas water heater replacement, covering ventilation, the safety valve and the connections. When a repair turns into a replacement, ask dispatch how the permit and inspection will be handled.

The Building Department is at 6530 W 79th Street, and its phone is 708-599-5500, option 2. The city also requires that plumbing contractors be licensed.

Repair or Replace: Questions That Decide It

The age and the leak location settle most decisions. Ask these before you approve a repair.

  • Is the tank itself leaking? If water is coming from the tank body, repair is not possible.
  • Is the heater near the end of a typical tank life, or has it been flushed and serviced?
  • Is the repair part a low-cost wear item such as a thermostat, element or relief valve?
  • Has the heater already needed a second repair this year?
  • Would a replacement qualify for a gas inspection and a new expansion tank at the same visit?

Our water heater replacement page covers what happens when the answer is to replace.

Hard Water Shortens Heater Life

Chicago, which supplies water to the South Stickney Sanitary District and nearby suburbs, reported hardness between 134 and 143 mg/L as calcium carbonate in its 2013 quarterly lab reports. That is roughly 8 grains per gallon by our conversion, and it is a 2013 figure, so ask the water utility for the current number.

Moderately hard water leaves scale on heating elements and the tank floor. Regular flushing and an anode rod check slow the damage.

How Water Heater Repairs Are Priced

The price depends on the part and the access, not the hour you call. Dispatch gives you the price before the visit and confirms it after the diagnosis.

PartA thermostat or element costs less than a gas control valve.
Fuel and ventGas work includes a venting and combustion check.
AccessA heater in a tight closet takes longer than one in an open basement.

If the diagnosis shows the tank has failed, we say so and give you the replacement option before any work begins.

Want your real number?Describe the job to dispatch and the price is agreed before work starts.

Standards That Apply to Water Heaters

Temperature and pressure relief valves are made to ANSI Z21.22, and a heater that discharges through one should be inspected rather than capped. Gas models are installed and serviced against NFPA 54, the National Fuel Gas Code that installers work from.

Ask the technician which standard applies to the part being replaced. A clear answer is a good sign.

Water Heater Repair FAQ

Yes. The line is open 24/7, so a leaking heater at 2 a.m. or a cold house on Sunday gets the same dispatch process as a weekday call. Same-day appointments are offered when a crew is available.

It depends on where it leaks. Leaks from fittings, the drain valve or the relief valve are repairable. A leak from the tank body means the steel has failed and the heater has to be replaced.

Sediment on the tank floor traps water that boils and pops. Flushing helps when it is caught early, and a tank with heavy sediment may be better replaced.

Close the cold water valve on the pipe above the heater. Then switch off the gas valve or the breaker. If you smell gas, leave the house and call the gas utility from outside.

The city requires a permit for plumbing alteration and offers a free inspection on gas water heater replacement. Dispatch can explain how it is handled for your address.

Not sure if your heater is worth fixing? Call and ask.

Call (773) 207-0518